This article needs additional citations for verification. (April 2013) (Learn how and when to remove this template message)
In geometry, a flat or Euclidean subspace is a subset of a Euclidean space that is itself a Euclidean space (of lower dimension). The flats in two-dimensional space are points and lines, and the flats in three-dimensional space are points, lines, and planes.
Flats are the affine subspaces of Euclidean spaces, which means that they are similar to linear subspaces, except that they need not pass through the origin. Flats occurs in linear algebra, as geometric realizations of solution sets of systems of linear equations.
A flat can be described by a system of linear equations. For example, a line in two-dimensional space can be described by a single linear equation involving x and y:
In three-dimensional space, a single linear equation involving x, y, and z defines a plane, while a pair of linear equations can be used to describe a line. In general, a linear equation in n variables describes a hyperplane, and a system of linear equations describes the intersection of those hyperplanes. Assuming the equations are consistent and linearly independent, a system of k equations describes a flat of dimension n − k.
while the description of a plane would require two parameters:
In general, a parameterization of a flat of dimension k would require parameters t1, … , tk.
Operations and relations on flatsEdit
Intersecting, parallel, and skew flatsEdit
If each line from one flat is parallel to some line from another flat, then these two flats are parallel. Two parallel flats of the same dimension either coincide or do not intersect; they can be described by two systems of linear equations which differ only in their right-hand sides.
If flats do not intersect, and no line from the first flat is parallel to a line from the second flat, then these are skew flats. It is possible only if sum of their dimensions is less than dimension of the ambient space.
For two flats of dimensions k1 and k2 there exists the minimal flat which contains them, of dimension at most k1 + k2 + 1. If two flats intersect, then the dimension of the containing flat equals to k1 + k2 minus the dimension of the intersection.
Properties of operationsEdit
These two operations (referred to as meet and join) make the set of all flats in the Euclidean n-space a lattice and can build systematic coordinates for flats in any dimension, leading to Grassmann coordinates or dual Grassmann coordinates. For example, a line in three-dimensional space is determined by two distinct points or by two distinct planes.
However, the lattice of all flats is not a distributive lattice. If two lines ℓ1 and ℓ2 intersect, then ℓ1 ∩ ℓ2 is a point. If p is a point not lying on the same plane, then (ℓ1 ∩ ℓ2) + p = (ℓ1 + p) ∩ (ℓ2 + p), both representing a line. But when ℓ1 and ℓ2 are parallel, this distributivity fails, giving p on the left-hand side and a third parallel line on the right-hand side.
- There is the distance between a flat and a point. (See for example Distance from a point to a plane and Distance from a point to a line.)
- There is the distance between two flats, equal to 0 if they intersect. (See for example Distance between two lines (in the same plane) and Skew lines#Distance.)
- There is the angle between two flats, which belongs to the interval [0, π/2] between 0 and the right angle. (See for example Dihedral angle (between two planes). See also Angles between flats.)
This section needs expansion. You can help by adding to it. (April 2013)
- In addition, a whole n-dimensional space, being a subset of itself, may also be considered as an n-dimensional flat.
- Can be considered as −1-flat.