Arene substitution pattern
Ortho, meta, and para substitutionEdit
- In ortho-substitution, two substituents occupy positions next to each other, which may be numbered 1 and 2. In the diagram, these positions are marked R and ortho.
- In meta-substitution the substituents occupy positions 1 and 3 (corresponding to R and meta in the diagram).
- In para-substitution, the substituents occupy the opposite ends (positions 1 and 4, corresponding to R and para in the diagram).
The toluidines serve as an example for these three types of substitution.
Electron donating groups, for example amino, hydroxyl, alkyl, and phenyl groups tend to be ortho, para directors, and electron withdrawing groups such as nitro, nitrile, and ketone, tend to be meta directors.
Although the specifics vary depending on the compound, in simple disubstituted arenes, the three isomers tend to have rather similar boiling points. However, the para isomer usually has the highest melting point, and the lowest solubility in a given solvent, of the three isomers.
Separation of ortho and para isomersEdit
Because electron donating groups are both ortho and para directors, separation of these isomers is a common problem in synthetic chemistry. Several methods exist in order to separate these isomers:
- Column chromatography will often separate these isomers, as the ortho is more polar than the para in general.
- Fractional crystallisation can be used to obtain pure para product, relying on the principle that it is less soluble than the ortho and thus will crystallise first. Care must be taken to avoid co-crystallisation of the ortho isomer. 
- Many nitro compounds' ortho and para isomers have quite different boiling points. These isomers can often be separated by distillation. These separated isomers can be converted to diazonium salts and used to prepare other pure ortho or para compounds.
Ipso, meso, and peri substitutionEdit
- Ipso-substitution describes two substituents sharing the same ring position in an intermediate compound in an electrophilic aromatic substitution. Me3Si, t-Bu, and iPr groups can form stable carbocation, hence are ipso directing groups.
- Meso-substitution refers to the substituents occupying a benzylic position. It is observed in compounds such as calixarenes and acridines.
- Peri-substitution occurs in naphthalenes for substituents at the 1 and 8 positions.
Cine and tele substitutionEdit
The prefixes ortho, meta, and para are all derived from Greek, meaning correct, following, and beside, respectively. The relationship to the current meaning is perhaps not obvious. The ortho description was historically used to designate the original compound, and an isomer was often called the meta compound. For instance, the trivial names orthophosphoric acid and trimetaphosphoric acid have nothing to do with aromatics at all. Likewise, the description para was reserved for just closely related compounds. Thus Berzelius originally called the racemic form of aspartic acid paraaspartic acid (another obsolete term: racemic acid) in 1830. The use of the prefixes ortho, meta and para to distinguish isomers of di-substituted aromatic rings starts with Wilhelm Körner in 1867, although he applied ortho prefix to a 1,4 isomer and the meta prefix to a 1,2-isomer.  It was the German chemist Karl Gräbe who, in 1869, first used the prefixes ortho-, meta-, para- to denote specific relative locations of the substituents on a di-substituted aromatic ring (viz, naphthalene). In 1870, the German chemist Viktor Meyer first applied Gräbe's nomenclature to benzene. The current nomenclature was introduced by the Chemical Society in 1879.
These terms can also be used in six-membered heterocyclic aromatic systems such as pyridine, where the nitrogen atom is considered as one of the substituents. For example, nicotinamide and niacin, shown meta substitutions on a pyridine ring, while the cation of pralidoxime is an ortho isomer.
- Morrison and Boyd, Organic Chemistry, Allyn and Bacon Inc, Boston, 1959. Ch.9, p. 250.
- Morrison and Boyd, Organic Chemistry, Allyn and Bacon Inc, Boston, 1959. Ch. 10, p. 290.
- Morrison and Boyd, Organic Chemistry, Allyn and Bacon Inc, Boston, 1959. Ch. 21, pp. 573-574.
- IUPAC, Compendium of Chemical Terminology, 2nd ed. (the "Gold Book") (1997). Online corrected version: (2006–) "cine-substitution". doi:10.1351/goldbook.C01081
- IUPAC, Compendium of Chemical Terminology, 2nd ed. (the "Gold Book") (1997). Online corrected version: (2006–) "tele-substitution". doi:10.1351/goldbook.T06256
- Wilhelm Körner (1867) "Faits pour servir à la détermination du lieu chimique dans la série aromatique" (Facts to be used in determining chemical location in the aromatic series), Bulletins de l'Académie royale des sciences, des lettres et des beaux-arts de Belgique, 2nd series, 24 : 166-185 ; see especially p. 169. From p. 169: "On distingue facilement ces trois séries, dans lesquelles les dérivés bihydroxyliques ont leurs terms correspondants, par les préfixes ortho-, para- et mêta-." (One easily distinguishes these three series – in which the dihydroxy derivatives have their corresponding terms – by the prefixes ortho-, para- and meta-.)
- Hermann von Fehling, ed., Neues Handwörterbuch der Chemie [New concise dictionary of chemistry] (Braunschweig, Germany: Friedrich Vieweg und Sohn, 1874), vol. 1, p. 1142.
- Graebe (1869) "Ueber die Constitution des Naphthalins" (On the structure of naphthalene), Annalen der Chemie und Pharmacie, 149 : 20-28 ; see especially p. 26.
- Victor Meyer (1870) "Untersuchungen über die Constitution der zweifach-substituirten Benzole" (Investigations into the structure of di-substituted benzenes), Annalen der Chemie und Pharmacie, 156 : 265-301 ; see especially pp. 299-300.
- William B. Jensen (March 2006) "The origins of the ortho-, meta-, and para- prefixes in chemical nomenclature," Journal of Chemical Education, 83 (3) : 356.